Simu T5 ZSP Manual Del Usuario página 8

FUNCTION « FABRIC TENSION » FOR PRODUCT WITH LOCKING SYSTEM (MANUAL OR AUTOMATIC SETTING)
8
This function is used to adjust the fabric tension (Locks) of the product with 3 possible threshold levels
(low-medium-high).
1
+
1- Run the product to the halfway position using the DOWN or UP button. Then press the STOP button to stop
the motor.
2- To activate this function press successively:
- For half a second press simultaneously « STOP » and « DOWN » buttons, and release. (no jog)
- For more than 3 seconds press simultaneously « STOP » and « DOWN » buttons, until the motor jogs.
The motor is now in programming mode for only 10 seconds, the motor is factory set at the medium level.
3- To increase the tension on the fabric, press the « UP » button until the motor makes a jog, the fabric tension
is now set to the upper threshold.
- To decrease the tension on the fabric, press the « DOWN » button until the motor makes a jog, the fabric
tension is now set to the lower threshold.
4- Confirm the new setting by pressing 2 seconds the « STOP » button, until the motor jogs. The new setting
is memorized.
OBSTACLE DETECTION: DEACTIVATION/ ACTIVATION
9
This function give the possibility to adjust the level or deactivate the obstacle detection during the downward
movement in case of untimely stops.
1
+
1- Run the product to the halfway position using the DOWN or UP button. Then press the STOP button to stop
the motor.
2- To activate this function press successively:
- For half a second press simultaneously « STOP » and « UP » buttons, and release. (no jog)
- For more than 3 seconds press simultaneously « STOP » and « UP » buttons, until the motor jogs.
The motor is now in programming mode for only 10 seconds, the obstacle detection is activated (medium
level) in the factory mode.
3- To deactivate or increase the level of Obstacle detection, press the « UP » button until the motor jog (see
drawing above).
- To activate or decrease the level of Obstacle detection, press the « DOWN » button until the motor jogs (see
drawing above).
4- Confirm the new setting by pressing 2 seconds the « STOP » button, until the motor jogs. The new setting is
memorized.
US
8/12
2
+
3 s
2s max.
2
+
3 s
2s max.
3
low medium
=>
3
low
medium
=>
4
high
2 s
4
deactivated
2 s