Publicidad
Idiomas disponibles
Idiomas disponibles
Non use of safety belts can cause damages to the patient. Check the tightness of the belts on the patient before
each utilization.
The patient's transport requires the employment of almost two trained and qualified operators. It is recommended the transport with
more than two operators in particular situations. (see § 3.3.).
4.5. CONSERVATION AFTER USE
The scoop stretcher, being built of rust-resisting and weatherproof materials does not require particular care if used in ordinary
conditions. It is however recommended to keep it in a close place, paying attention to protect locking devices and sliding parts from
dust and dirt, to obtain the best efficiency at the moment of utilization.
The scoops can be folded reducing the encumbrance and making easier their storing (fig. 7):
1.
lay down the closed stretcher in horizontal position (pos. 1);
2.
place itself beside the stretcher, near the feet zone profile,
3.
open the right and left locking devices and unthread the two feet profiles at the same time, until the folding joints are completely
got out (pos. 2);
4.
taking hold of the frame at feet extremity turning all this part until complete superposition with the bust zone profile (pos. 3);
5.
put the stretcher in the desired place.
Pos. 1
4.6. ANOMALIES AND RELATIVES INTERVENTIONS
The schedule reports the anomalies, with the relative causes and the suggested remedies, which might appear during the utilization
of the stretcher. In case of persisting disfunction, please don't insist applying personal solutions, but contact the Technical Assistance
of ME.BER. (§ 7.1.), as in case of anomalies not considered in the schedule.
Anomalies
The feet zone profiles cannot
be unthreaded
Faulty locking of feet zone
profiles' extraction
The feet profiles don't upset
Head/ feet side hook doesn't
lock
The safety belts can't be
opened or closed
The profiles turn
MAXIMA
Figure 7
Possible causes
Presence of extraneous bodies
Break of the device
Stopped hole
Stud not in correspondence with the hole
Break of the spring
Break of the stud
Joint(s) stopped for presence of extraneous
bodies
Joints not completely unthreaded
Presence of extraneous bodies
Break of the spring
Wear of the hook plate
Break of the hook
Break of the rivet/ thorn
Pos. 2
Remove the extraneous material/clean the profile
Renew the spring (contact the Technical
Assistance Service § 7.1.)
Clean the hole/remove the material which stops it
Line up the stud axis with the hole
Renew the spring (contact the Technical
Assistance Service § 7.1.)
Renew the stud (contact the Technical
Assistance Service § 7.1.)
Remove the extraneous material/ clean the
joint(s)
Unthread completely the joints
Remove/ clean the hook
Renew the spring (contact the Technical
Assistance Service § 7.1.)
Renew the hook plate (contact the Technical
Assistance Service § 7.1.)
Renew the belts
Renew the rivet/thorn (contact the Technical
Assistance Service § 7.1.)
24
Pos. 3
Remedies
II ed - Rev.2 210412
Publicidad
