Publicidad
Idiomas disponibles
Idiomas disponibles
INSTALLATION AND CONNECTION
Install the 5"/7" Monitor
When mounted in the cab, the Furrion
Vision S+ 7" monitor typically works as
an observation system together with a
Furrion rear mounted camera (for rear
observation) and two side cameras (for
traffic observation).
When mounted in the coach, the Furrion
Vision S+ 7" monitor typically works as a
security system together with a Furrion
doorway camera.
Insert a Micro-SD Card
Furrion Vison S+ monitor supports
Micro-SD card (at least Class 10, not
included) up to 128GB memory storage
capacity for video recording or firmware
upgrade.
Pull to open the rubber cover of the
Micro-SD card slot and insert a Micro-
SD card (not included).
NOTE: A Micro-SD card icon will appear
on the top of the monitor screen once a
Micro-SD card is inserted.
Mount in Cab for Observation
IMPORTANT: Choose a monitor
location in your vehicle that does not
block your view and complies with local
laws for safe driving. Do not place in an
area where it might interfere with driving.
1.
Choose a mounting method.
When using the Windshield
Mount: Clean the mounting area
and remove the protective film from
the bottom of the suction cup. Place
the suction cup onto the appropriate
location and pull the locking arm
downwards to stick the mount
securely.
When using the Interior Table
Stand: Place the table stand on a
flat stable surface, and route the
monitor power cable through hole as
shown.
NOTE: The table stand is designed
with four non-slip pads at the bottom
to enhance the stability.
2. Align the ball joint of the windshield
mount or the interior table stand
with the opening on the back of the
monitor and push hard to lock into
place.
- 10 -
CCD-0005512 Rev: 03-20-22
Publicidad
