Descargar Imprimir esta página

Furrion VISION S+ FOS7HTAEM Manual De Usuario página 15

Publicidad

Idiomas disponibles

Idiomas disponibles

reference only. You can mount Furrion
Vision S+ products onto various types
of RV such as trailers and Class A/B/C
motorhomes.
2. Remove the lens cover and detach
the camera from the marker light
bracket (right side camera shown).
3
#1 Phillips Head
3. Remove the original marker light
from the corresponding location.
4. Connect the bare ends of the power
cable on the back of the bracket to
the nearest 12V/24V power supply:
Side markers use 4 wires:
Red: +12V
Brown: Marker
Yellow: Trigger
Black: Ground
Rear marker uses 3 wires:
Red: +12V
Brown: Marker
Black: Ground
For left/right side camera
position: It is suggested to use
the power line for the original side
marker lights directly.
For rear camera position: It is
suggested to use the power line for
the original rear marker light directly.
1
2
#4 x 1/4" self-tapping
- 14 -
Example of a typical 7-way connection
FEMALE CONNECTOR, MALE PINS
Tail lights/running lights
(Brown)
Left turn signal &
brake light
(Yellow)
Ground
(Black)
Backup lights
This image is only for identifying the color code of the signal wires
and the user does not have to route the trigger wires to 7-way.
NOTE: Ensure that the fuse on
the connected power line provides
additional 1A fusing current for the
camera. Ensure proper cable isolation
for all bare ends (e.g., by using insulation
tape).
5. Secure the gasket and marker light
bracket onto your vehicle using
four #6 x 3/4" flat head self-tapping
screws. Apply sealant around the
gasket for better sealing.
#2 Phillips Head
Mount Cameras (right side
shown)
Reattach the camera to the marker light
bracket. Before fixing the camera, check
its pairing status with the monitor by
resuming power temporarily.
If you cannot see the video feed from
the camera on the monitor screen or
you have an unbundled camera, see
the separate Quick Start Guide of the
monitor or the "Pair with a Camera"
section of this manual for the pairing
procedures.
Auxiliary 12V+/charging
(Red)
Right turn signal &
brake light
(Green)
Trailer brake control
(Blue)
#6 x 3/4" flat head Self-tapping
CCD-0005512 Rev: 03-20-22

Publicidad

loading