Publicidad
Idiomas disponibles
Idiomas disponibles
1
#1 Phillips Head
For the rear camera, screw the
antenna onto the camera securely and
keep the antenna straight. Adjust the
view angle of the camera by rotating it
upwards and downwards (0~50°) so that
you can see the bottom edge of your
vehicle and the road conditions behind.
SYSTEM SETUP
Pair with a Camera
If the monitor comes in a bundle with one or more Furrion Vision S+ camera(s), it is
paired with the camera(s) by default. If you cannot see the video feed of the camera
on the monitor screen or you have an unbundled camera, follow the procedures
below to pair.
1.
Ensure the monitor is turned on.
NOTE: The monitor will be turned on automatically and shows the video feed(s)
of paired camera(s) once connected to the power source. If the monitor is off,
press the power button to turn it on.
2. Ensure the camera that is going to be paired has been installed and wired
properly. See the separate Quick Start Guide of the camera or the "Install
Doorway Security/Rear Camera" and "Install Side Cameras & Rear
Camera with LED Marker Light" section of this user manual for detailed
camera installation instructions.
3. Press the power button of the monitor to pop up the menu.
CCD-0005512 Rev: 03-20-22
3
2
#4 x 1/4" self-tapping
- 15 -
Torque: ≤8 In-lbs
For the left/right side camera,
ensure the lens on the camera is
facing backwards and the MONITOR
PAIRING button is facing downwards
after installation.
Publicidad
