Publicidad
Idiomas disponibles
Idiomas disponibles
to the bracket with four #4 x 1/4" self-
tapping screws.
#2 Phillips Head
3. Adjust the view angle of the camera
by rotating it upwards or downwards
(0~50°) so that you can see:
For rear camera position: the
bottom edge of your vehicle and the
road conditions behind.
For doorway camera position:
the bottom edge of the door.
Install Side Cameras &
Rear Camera with LED
Marker Light
Prepare
●
Prepare tools you may need,
including #1 and #2 Phillips head
screwdrivers, sealant, insulation
tape, pencil and/or a 5/8" hole saw
(needed only when drilling a new
hole).
CCD-0005512 Rev: 03-20-22
Mount LED Marker Light
pre-installed with a bracket for camera
installation.
and wiring operation, remove the key
from the ignition and isolate the 12V/24V
power source.
Always seek professional assistance if
you are unsure about the installation and
wiring operation.
#4 x 1/4" self-tapping
1.
- 13 -
NOTE: Skip this section if your RV is
IMPORTANT: Before any installation
Determine the mounting location
on your RV. Ensure that there is
no obstacle blocking the camera
view. To avoid drilling new holes,
it is recommended to replace the
original marker lights with Furrion
products directly as below:
–
For rear camera position:
Locate the original rear marker
light at the top center on the rear
of your RV. To accommodate
the camera, ensure that there
is at least 7.5" space between
the central points of the two
adjacent marker lights.
–
For side camera position:
Locate the original side marker
lights as near to the driver's
cab as possible and the height
from ground to the middle of the
trailer.
Rear Camera
Position
NOTE: The RV shown here is for
Side Camera
Position
Publicidad
