Dometic ACC3100D Instrucciones De Uso página 13

6. Press the
button to switch the ventilation system on.
10 Troubleshooting
Problem
The ventilation system does not switch
on.
The display does not respond.
The heat exchanger does not longer
rotate.
The ventilation system does not work
correctly.
The ventilation system does not work.
Water enters the vehicle.
Only for ventilation system with
LED light strip (optional): The LED
light strip does not work.
Possible cause
No power supply connected.
The voltage is too low (<12 V).
The display is dirty.
The display is defective.
The display is blocked.
A part in the ventilation system is de-
fective.
The ventilation system is not connect-
ed correctly.
The storage mode is active.
The heat exchanger is blocked.
The grilles on the outside of the venti-
lation system are covered.
The ventilation system is not connect-
ed correctly.
A part in the ventilation system is de-
fective.
The ventilation system is not connect-
ed correctly.
A part in the ventilation system is de-
fective.
The battery to which the ventilation
system is connected is empty.
The seal is damaged.
The LED light strip is defective.
Suggested remedy
Check the power supply.
Contact an authorized service
agent.
Clean the display with a slightly
damp cloth.
Contact an authorized service
agent.
Reset the display.
Contact an authorized service
agent.
Contact an authorized service
agent.
–
1.
Press the button to switch the
ventilation system off.
2.
Press the button to switch the
ventilation system on.
Remove leaves and other ob-
stacles from the air and climate
grilles.
Contact an authorized service
agent.
Contact an authorized service
agent.
Contact an authorized service
agent.
Contact an authorized service
agent.
Charge the battery.
Contact an authorized service
agent.
Contact an authorized service
agent.
EN
13