Publicidad
Idiomas disponibles
Idiomas disponibles
Automatic Tuning
For details on the buttons used in this section, see "Brief
descriptions of buttons used to receive broadcasts" on
page 26.
1
Press TUNER to light the button up.
The last received station is tuned in.
2
Press FM/AM to select the FM or AM band.
3
Press TUNING + or TUNING –.
Press the + button to scan from low to high; press the –
button to scan from high to low.
When the receiver reaches either end of the
band
Scanning is repeated in the same direction.
The receiver stops scanning whenever a station is
received.
4
To continue scanning, press TUNING + or TUNING –
again.
Downloaded from:
https://www.usersmanualguide.com/
Preset Tuning
For details on the buttons used in this section, see "Brief
descriptions of buttons used to receive broadcasts" on
page 26.
Before you can tune in a preset station, first do the
procedure "Presetting radio stations" below.
Presetting radio stations
1
Press TUNER to light the button up.
The last received station is tuned in.
2
Tune in the station that you want to preset using
Direct Tuning (page 26)‚ or Automatic Tuning (this
page).
3
Press MEMORY.
"MEMORY" appears in the display for a few seconds.
Do Steps 4 and 5 before "MEMORY" goes out.
4
Press SHIFT to select a memory page (A, B or C).
Each time you press the SHIFT button, the letter "A,"
"B" or "C" appears in the display.
5
Select a number by pressing it (0 to 9).
If "MEMORY" goes out before you press a numeric
button, start again from Step 3.
6
Repeat Steps 2 to 5 to preset another station.
To change a preset code to another station
Do Steps 1 to 5 to preset the new station to the code.
Note
If the AC power cord is disconnected for about one week, all the
preset stations will be cleared from the receiver's memory, and
you will have to preset the stations again.
EN
27
Publicidad
