SOMFY Sonesse 40 WF RTS Li-ion Instrucciones página 11

Sonesse 40 WireFree RTS Li-ion
3.6. ADJUSTING THE SPEED
͉
Orange LED blinks slowly in this mode.
1) Move the motorised product away from the end limits. Press and
hold the UP, MY and DOWN buttons simultaneously, until the
motorised product briefly moves Up and Down once. The motorised
product will move UP and Down automatically in 10 second cycles
and green LED blinks 5 times to validate entering in speed adjustment
mode.
2) To increase the speed, press and hold the UP button until the
motorised product briefly moves Up and Down. and green LED
blinks 5 times. Repeat as needed.
͉
Maximum speed is reached when the motorised product moves briefly
3 times in one direction and 3 times in the other direction. Red LED
blinks 3 times and 3 times intermittently.
3) To decrease the speed, press and hold the DOWN button until the motorised product briefly moves Up and
Down. Repeat as needed.
͉
Minimum speed is reached when the motorised product moves briefly 3 times in one direction and 3 times in the
other direction.
4) To confirm the new speed, press and hold the MY button until the motorised product briefly moves Up and
Down and green LED blinks 5 times.
3.7. TIPS AND ADVICE ON OPERATION
Observations
The motorised product
does not operate.
The motorised products
stops before its end limit
Copyright © 2019 - 2022 SOMFY ACTIVITES SA, Société Anonyme. All rights reserved.
Possible causes
The control point battery is low. LED
doesn't light when any button of a
paired control point is pressed.
Drive battery is low and requires
charge. Red LED blinks 5 times when
any button of a paired control point is
pressed.
RTS is deactivated. LED doesn't light
when any button of a paired control
point is pressed.
Thermal protection of the drive is on
(Red LED blinks slowly).
The drive has detected an obstacle
(solid Red LED).
1 1
2 2
3 3
Solutions
Change control point battery as required.
Plug in the charger.
Press drive PROG. button.
Wait for the drive to cool down (Red LED
will stop blinking when drive is ready to use.
Move the motorised product in the other
direction.
EN
10 s 10 s 10 s 10 s
4 4
9