Sony MDR-RF5000K Manual De Instrucciones página 16

Notes
• Do not input signals other than PCM to the DIGITAL IN jack. Be sure to set optical digital
output of a connected AV component to PCM. If multi-channel signals are input from a DVD
device, sound may not be transmitted. Note that excessive noise may occur if CD signals
recorded in MPEG-2AAC or DTS format are input to this unit.
• The optical digital connecting cable is an extremely high-precision device and is sensitive to
jolts and external pressure. Therefore, be careful when inserting and removing the cable plug.
• The digital input for the transmitter does not support sampling frequencies of 96 kHz. Set the
digital output setting of the DVD device to 48 kHz when using this system. Noise may be
heard when a 96 kHz digital signal is input.
Connecting cables (sold separately)
Use the optical digital connecting cable POC-15AB (mini-plug y rectangular plug) when
connecting the optical digital output mini-jack on portable DVD players, portable CD players, or
other digital components to the DIGITAL IN jack.
Notes on optical digital connecting cable
• Do not drop objects on the optical digital connecting
cable or expose the cable to shock.
• Grasp the plug to connect or disconnect the cable.
• Be sure that the ends of the optical digital connecting
cable are kept clean. Dust at the ends of the cable can
degrade performance.
• When storing the system, attach the cap to the end of the plug
and be careful not to fold or bend the optical digital
connecting cable with a bend radius less than 25 mm (1 inch).
16
US
Connection
Downloaded from: https://www.usersmanualguide.com/
The bend radius of the optical
digital connecting cable should be
no less than 25 mm (1 inch).
25 mm
(1 inch)