Sony MDR-RF5000K Manual De Instrucciones página 7

Rear Panel of the Transmitter
1 TUNE/ID SET button
(See pages 19 and 21 for details.)
Use this button when reception
deteriorates, or when using additional
headphones.
2 ATT (attenuator) switch
Set this switch to "0 dB" if the volume is
too low for analog input. Normally, this
switch should be set to "–8 dB."
3 LINE IN jacks
(See page 14 for details.)
Connect the audio output jacks on an
audio or video component (sold
separately), such as a video cassette
player or TV, to these jacks.
Downloaded from:
TUNE/ID SET
ATT
0dB
1 2
https://www.usersmanualguide.com/
R L
LINE IN
-8dB
DIGITAL IN DIGITAL OUT
3 4 5 6
4 DIGITAL IN jack
(See page 15 for details.)
Connect a DVD device, digital satellite/
TV receiver, or other digital component
(sold separately) to this jack.
5 DIGITAL OUT jack
(See page 15 for details.)
Connected components' digital signal
integrity retained when installed.
6 DC IN 9V jack
Connect the supplied AC power adaptor
to this jack. (Be sure to use the supplied
AC power adaptor. Using products with a
different plug polarity or other
characteristics can cause a malfunction.)
DC IN 9V
(THROUGH)
Preparation
7
US