Unpacking The Machine; Machine Setup - Tennant EX-CAN-10 Manual Del Operario

OPERATION
EN

UNPACKING THE MACHINE

1. Carefully check carton for signs of damage. Report
damages to carrier immediately.
2. Check carton contents for to ensure carton is
complete. Contact distributor for missing items.
1 - Machine
1 - 1.4M (4 1/2 ft.) Clean- out Vacuum Hose
1 - 4.6m (15 ft) Vacuum Hose
1 - 4.6m (15 ft) Solution Hose
1 - 7.6m (25 ft) Power Supply Cord

MACHINE SETUP

1. Remove solution tank lid. Using a hose or bucket,
fill tank with 38L (10 gal) of hot water, 60C (140F)
maximum (Figure 1).
ATTENTION: Use different buckets to fill and drain
machine to prevent solution system clogs.
WARNING: Do Not Use Flammable Liquids Or
Operate Machine In Or Near Flammable Liquids,
Vapors Or Combustible Dusts.
2. Add a recommended cleaning solution to the
proper dilution ratio.
FOR SAFETY: When using machine, follow mixing
and handling instructions on chemical containers.
ATTENTION: If using powdered cleaning
chemicals, mix chemical with water prior to adding
to the tank.
NOTE: If desired, water alone achieves excellent
cleaning results.
3. Replace solution tank lid after filling.
6
FIG. 1
4. Connect the vacuum hose to the vacuum inlet tube
located at the rear of machine. Then connect the
solution hose to quick coupler located below handle
(Figure 2).
5. Attach accessory tool to opposite end of hoses
(Figure 3).
6. If desired, lock the front casters to keep machine
stationary while cleaning (Figure 4).
FIG. 2
FIG. 3
FIG. 4
EX- CAN- 10 (04- 10)