Publicidad
Idiomas disponibles
Idiomas disponibles
B
Using the appliance
8
Make three 8 mm holes for the wall bracket. Attach it to the wall using the 2 screws
provided. Assemble the chimney onto the hood and attach them together with 2 screws.
Installation without external opening
Recycling version
Contact your supplier to obtain active carbon
filters to transform the extractor hood into
a recycling hood.
Installing the active carbon filter (cassette)
•
Check that the diameter of the active
carbon filter corresponds the outlet
diameter.
•
If necessary, remove the pre-installed
diameter adapter.
•
Position the active carbon filter on the
outlet and attach it in place by turning
anticlockwise.
Installing the active carbon filter (cut-out)
•
The metal filter has to be removed be-
fore the active carbon filter is installed.
•
To open the metal filter, press on
the locking device and pull the filter
downwards.
•
Place the precut filter on top of the
metal filter. Hold in position using the
metal rods (supplied according to the
model).
•
Replace the metal filter in its original
position.
10
EN
B
Using the appliance
NB
Make sure that the filter is properly attached; otherwise it could become
dislodged and cause a hazard.
The installation of a carbon filter reduces the extraction power of the hood.
Use
Control panel
11
On/Off
First speed button
Minimum speed
Second speed button
Average speed
Third speed button
Maximum speed
O/I LIGHT button
Switches the lighting system on and off.
CAUTION
For products which can be used in manual mode, we recommend that you switch
off the motor after 10 minutes when the cooking process is complete.
11
EN
Publicidad
