Bianchi OLTRE Manual De Uso Y Mantenimiento página 2

EN
AIR DEFLECTORS OLTRE PRO AND OLTRE RC
The Oltre Pro and Oltre RC products (excluding the Oltre frame) are equipped with Air Deflectors technology. The Air Deflectors system is applied to the
head tube of the frame (left and right side) by means of two screws of size M3x10 mm (see pictures 1a and 1b).
IMAGE 1A IMAGE 1B
The customer assumes all liability and consequences that may arise from participating in a UCI-regulated competitive event without having
removed the Air Deflectors, including disqualification from the competition in question. Therefore, the customer shall have no recourse in any
way and/or for any reason against the manufacturer.
REMOVAL INSTRUCTIONS FOR AIR DEFLECTORS
Unscrew the four Air Deflectors M3x10 mm fixing screws using a Torx T10 screwdriver. The frame is supplied with rubber caps for closing the
threaded holes, to be applied by pressure.(see images 2a and 2b).
IMAGE 2A IMAGE 2B
OLTRE PRO, OLTRE RC INTEGRATED HANDLEBAR
The integrated handlebar is a specific component of the Bianchi Oltre RC and Oltre PRO frame (excluding the Oltre frame).
It should be noted that failure to comply with the warnings and prescriptions contained in this package insert exempts the manufacturer from any
liability.
Any necessary assembly, maintenance or disassembly of the handlebar must be carried out ONLY by your specialist dealer.
NEVER perform any work on the handlebar. Such work requires specific technical knowledge, special tools and well defined expertise and may be carried
out ONLY by your specialist dealer. Adjusting the handlebar height to suit your needs requires experience, suitable tools and manual dexterity. You
should therefore leave all adjustment work to your specialist dealer.
DANGER! The handlebar stem is secured to the fork by means of two screws of different lengths and a tapered nut; the upper screw is 5x30
mm and the lower screw is 5x34 mm. Respect the order in which the screws are inserted and insert the nut as shown in image 3a and 3b
and not upside down as shown in image 4.
IMAGE 3A
WARNING! The Air Deflectors system is NOT approved by the UCI
(International Cycling Union) for professional use.
Following the above, the customer declares and acknowledges
that in order to participate in UCI regulated competitive cycling
races and/or events, the Air Deflectors must be removed by fol-
lowing the instructions below.
DANGER! Observe and use the screws supplied with the prod-
uct. The use of screws that are different and longer than 10 mm
may block the rotation of the steering, with the risk of serious
falls and accidents.
The manufacturer cannot be held liable for any consequences
that may arise from the use of screws other than those sup-
plied.
IMAGE 3B IMAGE 4