stayer BHL112BK Manual De Instrucciones página 22

= Battery charging time
= No load speed
rpm
= Tightening torque
= Percussions
ipm
= Wood drilling capacity
= Steel drilling capacity
= Stone drilling capacity
= Weight
= Sound power level
= Sound pressure level
= Vibration
The values given are valid for nominal voltages
[U]230/240 V-50/60 Hz - 110/120 V - 60Hz. For lower
voltage and models for specific countries, these values
can vary.
Declaration of Conformity
The undersigned: STAYER IBERICA, S.A.
With address at:
Calle Sierra de Cazorla, 7
Área Empresarial Andalucía - Sector 1
28320 PINTO (MADRID)
Tel.: +34 91 691 86 30 / Fax: +34 91 691 91 72
CERTIFIES
That the machine:
Cordless drill/screwdriver
Type:
Models: BHL112BK / BHL114K / BHL118K /
PBL120K / PBL122K / PBL141K /
PBL1420K / PBL142K / PBL181PK /
PBL1820PK / PBL182PK / PBL184PK
/ PBL202BL / PBL 204BL / PBL214K /
PBL218PK
We declare under our sole responsibility that this
product is in conformity with the following standards or
standardized documents: UNE EN 60745, according to
EU Regulations 2006/42/CE, 2004/108/CE.
Ramiro de la Fuente
Director General
Assembly
Battery Charging
f Use only the battery chargers listed on the
accessories page. Only these battery charg-
ers are matched to the lithium ion battery of
your power tool.
ENGLISH
21
Note: The battery is supplied partially charged.
To ensure full capacity of the battery, complete-
ly charge the battery in the battery charger be-
fore using your power tool for the first time.
The lithium ion battery can be charged at any
time without reducing its service life. Interrupt-
ing the charging procedure does not damage the
battery.
chine has been automatically switched off. The
battery can be damaged.
To remove the battery 5, press the battery un-
locking button 9 and pull the battery out of the
power tool toward the rear. Do not exert any
force.
The battery is equipped with a NTC temperature
control which allows charging only within a tem-
perature range of between 0º C and 45º C. A
long battery service life is achieved in this manner.
Observe the notes for disposal.
Changing the Tool
f Before any work on the machine (e. g .,
Open the keyless chuck 2 by turning in rotation
direction
the tool.
Firmly tighten the collar of the keyless chuck 2
by hand in rotation direction
cally locks the drill chuck.
The locking is released again to remove the tool
when the collar is turned in the opposite direction.
January 5, 2015
Dust/Chip Extraction
f Dusts from materials such as lead-containing
coatings, some wood types, minerals and
metal can be harmful to one's health. Touch-
ing or breathing-in the dusts can cause aller-
gic reactions and/or lead to respiratory infec-
tions of the user or bystanders.
21
Do not continue to press the
WARNING
On/Off switch after the ma-
(not aply to 202-204 models)
maintenance, tool change, etc.) as well as
during transport and storage, set the rota-
tional direction switch to the centre posi-
tion. Unintentional actuation of the On/Off
switch can lead to injuries.
, until the tool can be inserted. Insert
1
. This automati-
2