Publicidad
Idiomas disponibles
Idiomas disponibles
Step 16
Carefully stand your unit upright.
å
Before fastening the DOOR to your unit, be sure the mounting screw is against the stops as shown in the diagram. If it
å
isn't, loosen the mounting screw to slide it against the stops. Then tighten the mounting screw.
Fasten the DOOR (T) with the CURVED HINGES to the LEFT UPRIGHT (F) as shown in the lower diagram. Use the screws
å
in the HINGES. You should start each SCREW a few turns before completely tightening any of them.
Fasten a PULL (144K) to the DOOR (T). Use one SILVER 5/8" MACHINE SCREW (15S).
å
Peel the FELT DISCS from the FELT DISC CARD (1M). Stick two FELT DISCS on the DOOR where it comes in contact with
å
the RIGHT UPRIGHT (E).
Repeat this step for the other DOORS (T) with the STRAIGHT HINGES. They will be fastened to the ENDS (A and B).
å
See the next step for DOOR adjustments.
å
STRAIGHT HINGE
Hinge
144K
1M
SILVER 5/8" MACHINE SCREW
(3 used for the PULLS)
Stop
Mounting
screw
B
T
T
144K
1M
15S
CURVED HINGE
F
E
Stop
Mounting
screw
Hinge
A
Publicidad
