Publicidad
Idiomas disponibles
Idiomas disponibles
For charger: 29972 / 2978602
2
1
For charger: CAG801/2903102/29862
1
3
PROCEDIMIENTO DE CARGA (INDICADOR LED)
BATTERY IS CHARGING
FULLY CHARGED
BATTERY IS TOO WARM (REMOVE
FOR APPROX. 30 MINUTES TO
ALLOW TO COOL)
DEFECTIVE BATTERY (REMOVE
AND REPLACE WITH A NEW
BATTERY)
1. Put the battery pack into the charger.
• If the status LED blinks RED, remove the battery pack from the charger for 1
minute.
2. Put the battery pack into the charger again.
• If the status LEDs show correct, the battery pack is good.
• If the status LED stays blinking RED, remove the battery pack and disconnect
the charger.
3. Wait for 1 minute and put the battery pack into the charger again.
• If the status LEDs show correct, the battery pack is good.
• If the status LED stays blinking RED, the battery pack is defective and it is
necessary to replace the battery pack.
For charger: CAG817/ CAG812
3
2
5
1
3
GREEN BLINKING
GREEN
RED
RED BLINKING
EN
2
Publicidad
