Publicidad
Idiomas disponibles
Idiomas disponibles
6.2 EXAMINE THE CHARGER
EN
If the battery pack does not charge correctly:
1. Examine the current of the power outlet with different machines. Make
sure that the outlet works.
2. Examine that the charger contacts are not short-circuited.
3. If the charger is not under usual room temperature, move the charger and
battery pack to a location where the temperature is between 6° C to 40°
C (42.8° F to 104° F) .
If you attempt to charge the battery pack in a warm or hot environment, and the
charger LED light is red, remove the battery pack and let the battery cool for
approximately 30 minutes.
6.3 MOUNT THE CHARGER
1. Get the location of the wall to attach the charger.
2. Use 2 wood screws to attach the charger on the wood studs.
3. For charger CAG801/2903102/29862: Drill two paralleled holes 5" (127
mm) on center. For charger CAG817/ CAG812: Drill two paralleled holes
4.4" (112 mm) on center.
4. Use wall anchors and screws to attach the charger to the drywall.
CAG801/2903102/29862
If you do not use the battery pack and charger for a long time, please remove the
battery from the charger and pull out the AC power plug.
7. MAINTENANCE
7.1 CLEAN THE MACHINE
Keep the air vent free of blockage, saw dust, and wood dust. Do not spray, wash,
or submerge in water.
• Clear the unwanted material out of the air vent with a vacuum.
• Clean housing and the plastic components with a soft, dry cloth.
Do not use strong solvents or detergents on the plastic housing or components.
WARNING!
CAG817/ CAG812
NOTE
NOTE
IMPORTANT
6
Publicidad
