Sartorius YDP30 Instrucciones De Manejo página 10

Installation
4 Installation
4.1 Scope of Delivery
Item
Device
Power supply unit, type
WDS060240
Country-specific power
supply cable
YDP30 only
Printer connection
cable, type USB
Printer connection
cable, type RS232
Winding roller
Operating Instructions
4.2 Selecting an Installation Site
Procedure
Make sure that the following conditions are met at the
t
installation site:
Condition Features
Ambient Suitability tested (see Chapter "13 .2
conditions Ambient Conditions at the Installation
Site", page 23)
Setup surface − Stable, even surface with little
vibration
− Sufficient space for the device .
10 Operating Instructions YDP30 | YDP30-NET
Quantity Purpose
1
1
1
1
1
1 Used to wind the
ink ribbon
1
4.3 Unpacking
Procedure
Unpack the device .
t
Install the device at the intended installation site . The
t
device must not be dropped or shaken .
We recommend you keep the original packaging for a safe
t
and proper return of the device, e .g . for repairs .
4.4 Acclimatizing
When a cold device is brought into a warm environment: The
temperature difference can lead to condensation from
humidity in the device (moisture formation) . Moisture in the
device can lead to malfunctions .
Procedure
Allow the device to acclimatize for approx . 2 hours at the
t
installation site . The device must be disconnected from the
power supply during that time .
5 Getting Started
5.1 Connecting the Power Supply
Procedure
WARNING Severe injuries may be caused by using
t
defective power supply cables! Check the power supply
cable for damage, e .g ., cracks in the insulation .
If required: Please contact Sartorius Service .
t
Check whether the country-specific power plug matches
t
the power connections at the installation site .
If required: Please contact Sartorius Service .
t
Check whether the voltage specifications on the
t
manufacturer's ID label match those of the power supply at
the installation site .
If the input voltage is too high: Do not connect the
t
device to the power supply .
Please contact Sartorius Service .
t
Connect the power supply unit connection cable to the
t
"Power Supply" connection .
Connect the power supply cable to the power supply unit
t
and the power supply at the installation site . The power
outlet must be easy to reach .