Sartorius YDP30 Instrucciones De Manejo página 13

5.6.2 Inserting Release Paper of Self-adhesive Media
(Peel-off Mode)
If the release paper of self-adhesive media has been inserted:
The release paper will automatically be removed during
printing .
Requirements
The device is switched off .
Procedure
Open the top cover .
t
Open the front cover .
t
Separate the release paper
t
from the media and feed it
through the release paper
opening .
Close the front cover . The
t
front cover must snap into
place .
Close the top cover .
t
5.6.3 Setting the Print Roller to the Media Thickness
1
Fig . 5: Lever (set in the position for normal paper, example)
Pos. Name Description
1 Lever For setting the print roller .
2 Position for For setting the print roller to
normal paper normal paper thicknesses (for
media thickness, see Chap-
ter "13 .8 Media", page 25) .
3 Position for For setting the print roller to the
thick paper maximum paper thickness (for
maximum paper thickness, see
Chapter "13 .8 Media",
page 25) .
Requirements
The device is switched off .
Procedure
Open the top cover .
t
Fold the front cover downward .
t
Push the lever to the desired position, e .g . into the position
t
for thick paper .
Fold the front cover upward and let it snap into place .
t
Close the top cover .
t
5.6.4 Completing the Media Insertion
Procedure
Define the media sensor and calibrate the sensors (see
t
Chapter "7 .6 Calibrating Sensors and Changing Settings",
page 18) .
Operating Instructions YDP30 | YDP30-NET
Getting Started
2 3
13