Maintenance Of The Proneb ® Ultra Ii Compressor - Pari PRONEB Ultra II Instrucciones De Uso

between portable and mobile RF communications equipment and the
The PRONEB
®
ULTRA II is intended for use in an electromagnetic environment in which radiated RF disturbances are controlled.
The customer or the user of the PRONEB
distance between portable and mobile RF communications equipment (transmitters) and the PRONEB
below, according to the maximum output power of the communications equipment.
Rated maximum output power of
transmitter
W
0,01
0,1
1
10
100
For transmitters rated at a maximum output power not listed above, the recommended separation distance d in metres (m) can be
estimated using the equation applicable to the frequency of the transmitter, where P is the maximum output power rating of the
transmitter in watts (W) according to the transmitter manufacturer.
NOTE 1 At 80 MHz and 800 MHz, the separation distance for the higher frequency range applies.
NOTE 2 These guidelines may not apply in all situations. Electromagnetic propagation is affected by absorption and reflection from
structures, objects and people.
VII. Maintenance Of The PRONEB
W W i i n n g g T T i i p p ™ ™ T T u u b b i i n n g g M M a a i i n n t t e e n n a a n n c c e e : :
If there is any moisture or condensation in the Wing Tip™ Tubing after the treatment,
let the compressor run with only the tubing attached for a few minutes. The warm air
from the compressor will dry the moisture or condensation in the tubing. Use a damp
cloth to wipe the exterior of the tubing.
F F i i l l t t e e r r : :
The Air Filter on the front panel of the PRONEB
white. In time, the Air Filter will turn gray, which means it is time to replace it. You
must replace the filter immediately if it gets wet or becomes clogged. The Air Filter
will last for up to 500 hours before replacement. A good general rule is to replace
the Air Filter whenever you replace your PARI Reusable Nebulizer (every 6 months).
To remove the Air Filter, make sure the PRONEB
off. Use a coin to turn the Air Filter cover counter clockwise. Pull the cap and filter
out and remove the filter from the cap. Refer to p p a a g g e e 2 2 , , F F i i g g u u r r e e D D . To replace the filter,
press the new filter into the cap with the open end visible. Place the cap and filter
back into the front of the compressor. Use the coin to turn the filter cover clockwise
to tighten. Refer to p p a a g g e e 2 2 , , F F i i g g u u r r e e E E .
English
Recommended separation distances
®
ULTRA II can help prevent electromagnetic interference by maintaining a minimum
Separation distance according to frequency of transmitter
150 kHz to 80 MHz 80 MHz to 800 MHz
3,5
d = P d =
V
1
.12
.37
1.17 1.17
3.69 3.69
11.67 11.67
® ULTRA II Compressor
® ULTRA II Compressor is bright
® ULTRA II Compressor is turned
PRONEB ®
ULTRA II
®
ULTRA II as recommended
m
800 MHz to 2,5 GHz
3,5 7
P d = P
E E
1 1
.12 .23
.37 .74
2.33
7.38
23.33
10