ProBreeze PB-H16 Manual De Instrucciones página 5

Idiomas disponibles

HOW TO ATTACH TO WALL/CEILING

Step 1: On the L shaped Brackets (H), measure the pitch between the pair of holes desired

for use, with a ruler.

Step 2: Using a pen, mark the same distance where you are going to drill (determine hole

depth before hand).

Step 3: Using power drill and 8mm masonry drill bit, drill holes.

ENSURE THERE ARE NO WIRES OR PIPES BEHIND WALL.

Step 4: Fit explosion screws into wall, tighten nut D. Tighten each nut individually, a small

amount each until unit is firmly anchored.

Step 5: Connect heater attached L Brackets to explosion screw L Brackets (fitted into

wall) using components C & G as shown. Use 10mm spanner if necessary.

7 | English

OPERATING ANGLE

WALL ANGLE

•

Do not face heater at 90° towards ceiling.

•

Only face downwards at maximum angle 135° see below.

CEILING ANGLE

•

Do not face heater at 90° towards walls.

•

Do not face fan directly down 180°. Only face at 135° angles.

OPERATING INSTRUCTIONS

English | 8