Publicidad
Idiomas disponibles
Idiomas disponibles
HUMIDIFIER QUICK SET UP
Use these basic instructions to quickly set up your unit. Use the "Detailed Set Up
Instructions" on page 6 for additional set up and operational information.
UNPACK HUMIDIFIER
1. OPEN THE CARTON AND REMOVE PACKING AND LITERATURE ON TOP.
2. LIFT THE CHASSIS (TOP SECTION) OFF THE BASE BY FOLDING THE PIVOT LID UP,
AND LIFTING IT OUT, THEN PULL THE CABINET OUT OF THE CARTON.
ASSEMBLE THE UNIT
1. EMPTY THE CABINET OF ALL
CONTENTS AND INVERT IT TO
INSTALL THE CASTERS.
3.
INSTALL THE FLOAT AND RETAINER INTO POSITION.
PLACE THE RETAINER
CLIP ONTO THE FLOAT
BETWEEN THE TOP
TWO BUMPS.
PINCH THE CLIP TO-
GETHER AND INSERT
THE TAB INTO THE
BOTTOM OF THE
CENTER SLOT ON THE
CABINET BACK.
FOR HELP, CALL 1.800.547.3888 OR VISIT AIRCAREPRODUCTS.COM
VERIFY CONTENTS INSIDE CARTON
• TWO WICK ASSEMBLIES (EACH WITH TWO WICK
SECTIONS INSIDE.)
• FLOAT AND RETAINER CLIP
• PARTS KIT, CONTAINING:
♦ FOUR CASTERS
♦ MANUAL
REMOVE CASTERS
FROM PARTS BAG,
AND INSERT THEM
UNTIL SHOULDER
IS FLUSH WITH THE
FLOOR OF BASE.
2
2.
TURN THE CABINET OVER TO
REINSTALL CONTENTS.
Publicidad
