Safety Information
Saint Herblain, 2022/07/04
Pascal ROUSSY, R&D Manager
EU-type Examination
The notified body EMITECH with identification number
0536 performed the conformity assessment of the technical
documentation according to the procedure of Annex III
(Module B) of Directive 2014/53/UE and issued the EU type
examination certificate 21-I037_C.
UK Declaration of Conformity
We Ets Georges Renault, 38 rue Bobby
Sands, 44818 Saint Herblain, France, declare
under our sole responsibility that the product
(with name, type and serial number, see front
page) is in conformity with the following UK
Regulation(s):
The Restriction of the Use of Certain Hazardous Sub-
stances in Electrical and Electronic Equipment Regula-
tions 2012
Radio Equipment Regulations 2017
Designated Standards applied:
EN 62841-2-2:2014+C1:2016; EN 62311: 2008; EN 302
065-2:2016 v2.1.1; EN 301 489-33:2017 v2.2.0; EN 301
489-1:2019 v2.2.3; EN 61000-6-2:2019
Saint-Herblain, 2022/02/02
Pascal ROUSSY, R&D Manager
Authorities can request relevant technical information from:
UK Authorized Representative:
Air Compressors & Tools Ltd
Zodiac – Unit 4, Boundary way
Hemel Hempstead Industrial Estate, HP27SJ Hempstead
Hertfordshire – UK
Contact: M.Taylor
WEEE
Information concerning Waste of Electrical and Electronic
Equipment (WEEE):
This product and its information, meets the requirements of
the WEEE directive/regulations (2012/19/EU), and must be
handled in compliance with the directive/regulations.
The product is marked with the following symbol:
Products marked with a crossed-out wheeled bin symbol and
a single black bar underneath, contain parts that must be han-
dled in compliance with the WEEE directive/regulations. The
entire product, or the WEEE parts, can be sent to your "Cus-
tomer Center" for handling.
FCC compliance Class A
This device complies with Part 15 of the FCC Rules. Any
changes or modifications not expressly approved by the man-
ufacturer could void the user's authority to operate this de-
vice.
Operation is subject to the following two conditions:(1) this
device may not cause harmful interference, and (2) this de-
vice must accept any interference received, including inter-
ference that may cause undesired operation.
FCC Responsible party:
Name: Mark Johnson
Position: General Manager
Address: Chicago Pneumatic Tool Company
LLC 1815 Clubhouse Road Rock Hill
SC 29730
USA
Mobile: +1 800 624 4735
Email: mark.johnson@desouttertools.com
NOTE: This equipment has been tested and found to
comply with the limits for a Class A digital device, pur-
suant to Part 15 of the FCC Rules. These limits are de-
signed to provide reasonable protection against harmful
interference when the equipment is operated in a com-
mercial environment. This equipment generates, uses,
and can radiate radio frequency energy and, if not in-
stalled and used in accordance with the instruction man-
ual, may cause harmful interference to radio communi-
cations. Operation of this equipment in a residential area
is likely to cause harmful interference in which case the
user will be required to correct the interference at his
own expense. Any changes or modifications to this
equipment not expressly approved by Desoutter may
cause, harmful interference and void the FCC authoriza-
tion to operate this equipment.
IC compliance Class A
CAN ICES-3(A)/NMB-3(A)
(English) This device complies with Innovation, Science and
Economic Development Canada's licence-exempt RSSs. Op-
eration is subject to the following two conditions:
1) This device may not cause interference; and
2) This device must accept any interference, including inter-
ference that may cause undesired operation of the device.
(French) Le présent appareil est conforme aux CNR d'Inno-
vation, Sciences et Développement économique Canada ap-
plicables aux appareils radio exempts de licence. L'exploita-
tion est autorisée aux deux conditions suivantes:
1) l'appareil ne doit pas produire de brouillage;
2) l'appareil doit accepter tout brouillage radioélectrique
subi, même si le brouillage est susceptible d'en compromet-
tre le fonctionnement
4 / 100
07/2022