vivi M026TGB Manual De Usuario página 14

5.5 Installation of saddle
Connect the seat and seat tube first. Insert the seat tube into rod receiver, and adjust the
position and height according to your riding habit. Tighten the seat with clamps. Notice:
Please do not exceed the maximum saddle height. Do not lift the saddle to the position
above the safety line.
5.6 Installation of rear reflector
Take out the red reflector, install the reflector on the saddle tube, and tighten the screws
with the tool No. 9 (cross screwdriver) to complete the installation of the rear reflector.
5.7 Installation of battery
Open the battery box, put the battery in a correct angle, insert
it into the bracket gently, and press it for automatic locking.
Insert the key into the keyhole and rotate to align the key with
the "off" icon. At this time, the battery is locked and cannot be
removed. If you need to remove the battery, please follow the
instructions in 6.3.2 to complete the operation.
Adjust the angle of Brake levers, Meter, gear lever, accelerator and bell on the
handlebar, and tighten them with tools.
Congratulations! You have assembled the whole bike.
10