Abicor Binzel EWR 2 Manual De Instrucciones página 40

7 Operation
7.3.2 Error messages following diagnosis
Potential error messages following diagnosis or if an error occurs during operation are shown below. If a new error occurs,
it is saved in the log book and is added to the actual value display.
1 Press the <OK button (4)> to start a new diagnosis run.
 7.3.3 Actual value displays on page EN-12
All errors are shown on the display (17).
 10.1 Error message after diagnosis/during operation on page EN-18
Tab. 19 Error messages following diagnosis
7.3.3 Actual value displays
Volume flow regulation
Display (13) Action
1 Press the <▲▼ touch buttons (3)>
to set the base flow.
2 Press the <OK button (4)> or
<power button (ESC) (18)>.
Tab. 20 Actual value displays for volume flow regulation
Outlet pressure regulation
Display (13) Action
Tab. 21 Actual value displays for outlet pressure regulation
EN - 12
Description
This start screen appears after diagnosis is finished with no errors.
The base flow can be set in this display only with Setter or Service
authorization.
The input is saved and completed; or press ESC to return and
discard the last change.
These actual value displays are for informational purposes only.
Values cannot be changed.
Description
These actual value displays are for informational purposes only.
Values cannot be changed.
EWR 2 / EWR 2 Net
BAL.0598 • 2018-04-09