Parkside PBS 600 A1 Instrucciones De Utilización Y De Seguridad página 37

Introduction / General safety advice for electrical power tools
Technical information
Q
Belt sander PBS 600 A1
nominal voltage: 230 V ~ 50 Hz
nom. power input: 600 W
no-load belt speed: 170 - 250 m / min
Sanding belt: 75 x 457 mm
Protection class:
Noise and vibration data:
Measured values for noise are determined in accor-
dance with En 60745. The A-weighted noise level
of the electrical power tool are typically:
Sound pressure level: 87.80 dB(A)
Sound power level: 98.80 dB(A)
Uncertainty K: 3 dB
Wear ear protection!
Total vibration, En 60745:
Vibration emission value a
Uncertainty K = 1.5 m / s
2
The vibration level given in these
instructions has been measured in accordance with
a standardised measurement procedure specified
in En 60745 and can be used to compare devices.
Different uses of the device give rise to different vi-
bration levels and in many cases they may exceed
the values given in these instructions. It is easy to
underestimate the vibration load if the electrical power
tool is used regularly in particular circumstances.
Note: If you wish to make an accurate assessment
of the vibration loads experienced during a particu-
lar period of working, you should also take into
account the intervening periods of time when the
device is switched off or is running but is not actual-
ly in use. This can result in a much lower vibration
load over the whole of the period of working.
All manuals and user guides at all-guides.com
= 6.446 m / s
2
h,CW
General safety advice for
electrical power tools
Read all the safety advice
and instructions! Failure to observe the safety
advice and instructions may result in electric shock,
fire and / or serious injury.
Keep all the safety advice and instructions
in a safe place for future reference!
The term "electrical tool" used in the safety advice
refers to electrical tools powered by mains electrici-
ty (by means of a mains lead) and electrical tools
powered by rechargeable batteries (without a
mains lead).
1. Workplace safety
a) Keep your working area clean and
well lit. Untidy or poorly lit working areas
can lead to accidents.
Do not work with the device
b)
in potentially explosive envi-
ronments in which there are
inflammable liquids, gases or dusts.
Electrical power tools create sparks, which can
ignite dusts or fumes.
c) Keep children and other
people away while you are
operating the electrical tool.
Distractions can cause you to lose control of
the device.
2. Electrical safety
a) The mains plug on the device must match
the mains socket. The plug must not
be modified in any way. Do not use
an adapter plug with devices fitted
with a protective earth. Unmodified
plugs and matching sockets reduce the risk of
electric shock.
b) Avoid touching earthed surfaces such
as pipes, radiators, ovens and refrig-
erators with any part of your body.
GB/MT 37