Worx WG761E Manual De Instrucciones página 15

these instructions.
This tool may cause hand-arm vibration syndrome if its
use is not adequately managed.
WARNING: To be accurate, an estimation of exposure
level in the actual conditions of use should also take
account of all parts of the operating cycle such as the times
when the tool is switched off and when it is running idle but
not actually doing the job. This may significantly reduce the
exposure level over the total working period.
Helping to minimise your vibration exposure risk.
ALWAYS use sharp chisels, drills and blades.
Maintain this tool in accordance with these instructions and
keep well lubricated (where appropriate).
If the tool is to be used regularly then invest in anti vibration
accessories.
Plan your work schedule to spread any high vibration tool use
across a number of days.
OPERATION INSTRUCTION
NOTE: Read instruction handbook before
operation this machine.
INTENDED USE
This product is intended for domestic lawn mowing.
ASSEMBLY & OPERATION
ACTION
ASSEMBLY
Lifting the handle bar
NOTE: Press and hold Quick-release
button during operation.
Assembling the grass collection bag
Attaching the grass collection bag to
the lawn mower
NOTE: Depress the grass collection
bag slightly to ensure that it is
completely installed.
NOTE: Push the mulching-bag switch
lever to open the mulching outlet
before fitting the grass collection
bag.
Assembling the side-discharge chute
NOTE: Remember to remove the
grass collection bag firstly and then
push the mulching-bag switch lever
to close the mulching outlet before
assembly.
Cordless Lawn Mower
Removing /fitting the basecamp
NOTE: When fitting, gently pull the
basecamp to ensure that it is securely
installed.
NOTE: After fitting, tighten the
basecamp power output and the
mower with a cable tie to ensure
a reliable connection. It is not
recommended to remove the cable
tie.
Fitting/removing the battery pack
Insert the safety key before installing
the battery pack.
NOTE: This machine will only run
when sp-batteries are installed. It is
recommended to use the same Ah
batteries and charge the 4 batteries
at the same time.
When you use 4 batteries with
different Ah, the machine will only run
to the lower common denominator.
Checking the battery charge
condition
NOTE: Fig. G only applies for the
battery pack with battery indicator
light.
Charging the battery pack
NOTE: The batteries are shipped
FIGURE
uncharged. Each battery must be fully
charged before the first usage.
Always fully charge the 4 batteries at
same time. More details can be found
See Fig. A
in charger's manual.
NOTE: Always charge the battery pack
with the basecamp on the mower.
See Fig. B
Power indicator light
See details in BATTERY STATUS part
See Fig.
C1-C3 Press the battery indicator button, the
light will be on to indicate the lower
common denominator, after 3s, status
of each battery pack will be shown on.
OPERATION
Starting and Stopping
NOTE: Place the Mulching-Bag Switch
Lever in the bag position after each
See Fig. D1,D2
use. (See Fig. C1)
Operating the self-propel system
Adjusting the cutting height
motor stops before adjusting height.
The blades continue to rotate after
the machine is switched off, a rotating
blade can cause injury. Do not touch
rotating blades.
WARNING! Stop, release
Operating Bail and wait until the
See Fig. E1-E4
See Fig. F1, F2
See Fig. G
See Fig. H
15
See Fig. I
See Fig. J1, J2
See Fig. K
See Fig. L
EN