Babify Onboard Swivel 360 Manual De Instrucciones página 48

EN
48
NOTICE
Group 0, I
Rearward Facing: ISOFIX + Top Tether Installation
1. Regulation No.44/04 series of amendments, for general use in vehicles
fitted with ISOFIX anchorage system.
2. It will fit vehicle with positions approved as ISOFIX positions(as detailed in
the vehicle handbook). depending on the category of the child seat and of
the fixture.
3. The mass group and the ISOFIX size class for which this device is intended
is: Rearward facing Group 0, Class E ; Group I, Class D
Group 1,2,3
ISOFIX and Safety belts installation
This child restraint is classified for "Semi-universal" use and is suitable for
fixing into the seat positions of the following cars.
CAR
refer to
vehicle list
Seat positions in other cars may also be suitable to accept this child restraint.
Please refer to the information documents or the retailer's website for the
suitable car model list.
If in doubt, consult either the child restraint manufacturer or the retailer any
time.
Group 0, I, II, III Vehicle safety belts Installation
1. This is a "Universal" child restraint. It is approved to Regulation No. 44/04
series of amendments, for general use in vehicles and it will fit most, but
not all car seats.
2. A correct fit is likely if the vehicle manufacturer has declared in the vehicle
handbook that the vehicle is capable of accepting a "Universal" child
restraint for this age group.
3. This child restraint has been classified as "Universal" under more stringent
conditions than those which applied to earlier designs which do not carry
this notice.
FRONT
Outer
Yes
Yes
REAR
Centre
Yes