Star Power AS01 Manual De Usuario página 10

06 Maintenance
Proper maintenance helps keep the treadmill in the best condition while improper mainte-
nance may damage or shorten the life span of the treadmill.
Warning:
Before cleaning or performing the maintenance of the treadmill, make sure to turn off and unplug the
treadmill.
1.Dedust the treadmill on regular basis to keep the parts clean.
2.After using the treadmill each time, wipe the meters and other parts with a clean towel or cloth to remove the sweat and
debris. Be careful to keep the electrical components and running belt away from water.
3.Keep the treadmill in a clean and dry environment and make sure the power is off and the treadmill is unplugged.
4.To facilitate the moving of the treadmill, it is equipped with wheels. Before moving the treadmill, make sure to disconnect
the power supply and fold the treadmill properly.
5.Check all parts of the treadmill frequently and lock them properly, and replace the damaged part immediately if any.
6.To better maintain and extend the life span of the treadmill, it is highly recommended to limit the exercising within 30
minutes each time and let the treadmill cool down for 10 minutes before restart.
7.The running belt has been properly adjusted at ex-work stage, but after using, the running belt may be stretched more or
less, which may cause damage to the belt due to its deviation from the center and rubbing against the side bars and the rear
cover. It is common to see the running belt stretched after using for a while. If the running belt becomes slippery or stuck
when using the treadmill, you may adjust the tightness of the running belt to improve the condition.
15
06 Maintenance
A. Belt adjustment.
If the running belt becomes too loose, insert the hex Allen Wrench provided with the treadmill into the adjustment hole at
the left foot guard of the treadmill, turn it by 1/4 of the cycle clockwise, and repeat the same process with the right foot
guard. Keep in mind to adjust both sides synchronously to tighten the belt while avoiding its deviation from the center. If
the running belt is too tight, adjust the both sides synchronously counterclockwise.
Note:
The running belt cannot be too tight, which may cause damage to the running belt or the roller bearings due to
increased pressure on the front/rear rollers, or result in abnormal noises or other problems. Adjust the running belt to the
appropriate tightness only to make sure there' s no slipping.
16