Star Power AS01 Manual De Usuario página 6

03 Assembly
Step 4
Product usage: when the power is on, wait till the light in the electronic panel to turn on. The treadmill is ready for use
with a single press of the START button!
(Note:
The safety lock must be placed on the yellow sticker in the middle under the meters to start the treadmill. If the
electronic panel displays "SAFE", it means the safety lock is not placed or not in the right position.
Emergency stop:
After the safety lock is pulled off, the power supply is disconnected, but the weak current remains.
The operation is not controlled by the software associated with the treadmill. For your safety: When exercising, be sure to
use the safety lock!
Note:
Upon confirming the assembly is completed strictly following above-mentioned requirements, lock all the screws
and double check to ensure there is nothing missing before turning on the power.
07
Safety lock:
Place the end of the magnet on top
of this label.
)
03 Assembly
Step 5
Folding:
fold the treadmill as shown in the figure below if it is not used for a long time. First, loosen the special bolt in the
column with a T-shaped Hex Allen Wrench in the direction of the arrows and unplug the power cord (5) in the direction of
the arrow, place the column back to the main frame in the direction of the arrow, hold the rear end of the treadmill with
your hands, lift the treadmill slowly in the direction of the arrow, and lean it against a wall.
Unfolding:
lay the treadmill flat on the floor as shown in the figure below, lift the column slowly in the direction of the
arrow, and use the T-shaped Hex Allen Wrench to tighten the special bolt in the column in the direction of the arrow, and
plug the power cord (5).
08