Makita DHS782 Manual De Instrucciones página 14

Cutting operation
CAUTION:
Wear dust mask when performing
cutting operation.
CAUTION:
Be sure to move the tool forward
in a straight line gently. Forcing or twisting the tool
will result in overheating the motor and dangerous
NOTE:
as room temperature. Then, the tool can work to its
grip and rear handle. Use both to best grasp the tool.
the circular saw blade. Set the base on the workpiece
contact. Then turn the tool on and wait until the circular
the circular saw blade and lead to dangerous kickback
cular saw blade to stop and then withdraw tool. Realign
tool on new cut line, and start cut again. Attempt to
avoid positioning which exposes operator to chips and
Rip fence (Guide rule)
CAUTION:
securely installed in the correct position before
use.
kickback.
1
1. Rip fence (Guide rule) 2. Clamping screw
against the side of the workpiece and secure it in posi-
tion with the clamping screw on the front of the base. It
also makes repeated cuts of uniform width possible.
Guide rail
Optional accessory
Place the tool on the rear end of guide rail. Turn two
the splinter-guard along the full length with a stroke.
Now the edge of the splinter-guard corresponds to the
cutting edge.
-
-
1.
14 ENGLISH
Make sure that the rip fence is
2
1