Makita DHS782 Manual De Instrucciones página 9

NOTE: Depending on the conditions of use and the
Switch action
WARNING:
Before installing the battery car-
tridge into the tool, always check to see that the
switch trigger actuates properly and returns to
the "OFF" position when released.
WARNING:
by taping down or some other means. A switch with
WARNING:
NEVER use the tool if it runs when
you simply pull the switch trigger without press-
for proper repairs BEFORE further usage.
Release the switch trigger to stop.
2
1. Switch trigger 2.
NOTICE:
Do not pull the switch trigger hard
cause switch breakage.
CAUTION:
The tool starts to brake the cir-
cular saw blade rotation immediately after you
respond the reaction of the brake when releasing
the switch trigger. Sudden reaction can drop the tool
Automatic speed change function
This tool has "high speed mode" and "high torque
mode".
depending on the work load. When the work load is low,
the tool will run in the "high speed mode" for quicker
cutting operation. When the work load is high, the tool
will run in the "high torque mode" for powerful cutting
operation.
A switch in need of repair
1
This can
1
1. Mode indicator
The mode indicator lights up in green when the tool is
running in "high torque mode".
If the tool is operated with excessive load, the mode
indicator will blink in green. The mode indicator stops
load on the tool.
Mode indicator status
On
Adjusting depth of cut
CAUTION:
After adjusting the depth of cut,
always tighten the lever securely.
Loosen the lever on the depth guide and move the base
up or down. At the desired depth of cut, secure the base
For cleaner, safer cuts, set cut depth so that no more
proper cut depth helps to reduce potential for danger-
1. Lever
9 ENGLISH
Operation
mode
Blinking
High speed
mode
High torque
mode
Overload
alert
1