Overload Protection; Overheat Protection - Makita DHS782 Manual De Instrucciones

CAUTION:
Always install the battery cartridge
fully until the red indicator cannot be seen. If not,
CAUTION:
Do not install the battery cartridge
forcibly.
NOTE:
cartridge.
Tool / battery protection system
placed under one of the following conditions.

Overload protection

When the tool is operated in a manner that causes it to
application that caused the tool to become overloaded.
Then turn the tool on to restart.

Overheat protection

ation, let the tool cool down before turning the tool on again.
On
Overdischarge protection
when the switches are operated, remove the batteries
from the tool and charge the batteries.
Indicating the remaining battery
capacity
1
2
1
1.
Blinking
2. Check button
Battery indicator status
On
-
-
Indicating the remaining battery
capacity
Only for battery cartridges with the indicator
-
1. Indicator lamps 2. Check button
light up for a few seconds.
Indicator lamps
Lighted
8 ENGLISH
Remaining
battery
capacity
Blinking
50% to 100%
20% to 50%
0% to 20%
Charge the
1
2
-
Remaining
capacity
Blinking
75% to 100%
50% to 75%
25% to 50%
0% to 25%
Charge the
malfunctioned.