Vitamix VM0100 Manual De Instrucciones página 5

Lid Plug Lock
FIGURE A
Top view of the lid showing the Locking Icons
Press in above the container
tab to remove the lid
Container tab
FIGURE B
Press in above the container
tab to remove the lid
Rim
Side lid latch
32
OUNCES
26
FIGURE C
20
14
8
2
FIGURE D
p
a R t S a n d
Lid Plug Unlock
Position indicator tab
Rim
Position indicator tab
4
CUPS
3
2
1
FIGURE E
f
e at u R e S
Two-Piece Lid - 2.0-litre Polycarbonate Container (FIGURE B)
The two-piece lid is easy to clean and easy to put on and take off.
· The lid has a continuous rim which latches inside the container tabs. Push one side of the rim
under one tab, and with the heel of your hands push down, over the opposite tab, to snap the
lid into position.
· To remove the lid, place your hands around the lid, pressing your thumbs above one of the
container tabs. Push in and lift off.
· To secure the lid plug: (FIGURE A) Position the lid plug over the lid and align either of the position
indicator tabs with an unlocked icon. Press the plug into the lid and turn until an indicator tab is
aligned with one of the locked icons. (Turn the lid over to be sure that plug is properly locked –
the locking feet must be seated into the lid-locking notches.) The bottom surface of the plug
should be snug against the top of the lid.
· The lid plug can be removed when using the tamper or adding ingredients. Turn the plug to an
unlocked icon to remove.
CAUTION: Do not use the one-piece lid when processing hot ingredients. Not for use with a
tamper.
Two-Piece Lid - 0.9-litre Polycarbonate Stackable Container (FIGURE C)
The two-piece lid is easy to clean and easy to put on, take off and seal.
· Push the lid into the container until the side latches are snapped under the container lip.
· To remove the lid, pull up gently on the side lid latches.
· To secure the lid plug: (FIGURE A) Position the lid plug over the lid and align either of the position
indicator tabs with one of the unlocked icons. Press the plug into the lid and turn until an indicator
tab is aligned with a locked icon. (Turn the lid over to be sure that the plug is properly locked - the
locking feet must be seated into the lid-locking notches). The bottom surface of the plug should
be snug against the top of the lid.
· The lid plug can be removed when using the tamper or adding ingredients. Turn the plug to an
unlocked icon to remove.
Two-Piece Lid - 1.4-litre Polycarbonate/Stackable Container (FIGURE D)
The two-piece lid is easy to clean and easy to put on, take off and seal.
• Push the lid into the container until the side latches snap under the container lip.
• To remove a fully latched lid, squeeze the tabs together on both sides of the container, then pull
upwards and off.
• The lid plug can be removed when using the tamper. Twist the plug to fasten or remove.
Two-Piece Lid - 0.9-litre Advance® Container (FIGURE E)
• The two-piece lid is easy to clean and easy to put on, take off and seal.
• To remove a fully latched lid, lift the two tabs and pull upwards and off.
• Twist the centre lid plug to fasten or remove.
One-Piece Lid (Optional) - 0.9-litre Advance® Container (FIGURE F)
• The one-piece lid is easy to clean and easy to put on, take off and seal.
• There is no lid plug for this lid.
• Add the ingredients through the port on the top.
FIGURE F
5