Publicidad
Idiomas disponibles
Idiomas disponibles
7 OPTIONAL
7.1
14
Optional locking cylinder for the cover lock
500637-01
500638-01
500517-01
500518-01
500633-01
Installing the locking cylinder
–
9
Insert springs
(included) into chambers
E
.
Tip
The kit contains many small parts. It is recommen-
ded that you perform the assembly while seated at
a table.
–
8
(included) with the number 1 into
Insert tumblers
A
C
chambers
,
, and
–
Insert the key and check whether the tumblers with the
number 1 are correct.
Guideline
The tumblers must close flush with the locking cylinder.
–
Replace the non-matching tumblers with ones that have
the matching number.
Tip
It is recommended that you note the numbers of
the matching tumblers so that the subsequent
locking cylinders can be equipped immediately.
–
Repeat the steps for chambers
first six chambers are fitted with the correct tumblers.
–
Insert the key.
Guideline
The tumblers must close flush with the locking cylinder.
–
Grease and mount the O-ring
Long-life grease (
–
Position and insert locking cylinder as shown.
The engaging plate
bl
Engaging plate
–
Pull up the locking device.
–
Position locking plate
locking cylinder as shown.
A
C
,
E
.
B
D
F
,
, and
until the
bk
(included).
p. 16)
bl
points downward.
engages.
4
(included with the case) on the
, and
Publicidad
