Publicidad
Idiomas disponibles
Idiomas disponibles
5 ASSEMBLY
10
–
Insert the key and check whether the tumblers with the
number 1 are correct.
Guideline
The tumblers must close flush with the locking cylinder.
–
Replace the non-matching tumblers with ones that have
the matching number.
Info
It is recommended that you note the numbers of
500517-01
the matching tumblers so that the subsequent
locking cylinders can be equipped immediately.
–
Repeat the steps for chambers
first six chambers are fitted with the correct tumblers.
–
Insert the key.
Guideline
The tumblers must close flush with the locking cylinder.
500518-01
–
Grease and mount the O-ring
Long-life grease (
–
Position and insert locking cylinder as shown.
The engaging plate
Engaging plate
500624-01
–
Pull up the locking lever.
–
Position locking plate
der as shown.
The plate faces to the right.
–
Mount and tighten screw
ded).
Info
The locking plates with notch
500625-01
needed for the cover's optional lock installation, see
Section 7
–
Key position 90° to the left to open.
–
Key position upward for locking.
500626-01
B
D
F
,
, and
bk
(included).
p. 16)
bl
points downward.
bl
engages.
3
(included) on the locking cylin-
5
6
with washer
(both inclu-
4
(included) are
until the
Publicidad
