Cleaning And Maintenance - HSM Classic 102.2 Instrucciones De Servicio

6 Troubleshooting
Paper jam
You have fed in too much paper.
Notice Do not press rocker switch alter-
nately forwards/backwards ( - ). Cutting
unit could be damaged.
• Press rocker switch .
 Pa per is pus hed out.
• Se pa ra te pa per stack.
• Press rocker switch .
• Feed in pa per successively.
Shredded material container full
Notice Empty the cut material container,
immediately because if it is too full, malfunc-
tions can occur in the cutting system.
• Press automatic start stop control
for 2 sec.
• Switch equipment off. To do this
tap rocker switch .
• Empty cut material container.
Shredded material container contact
interrupted (Cross cut only)
 Paper shredder switches off.
• Check whether shredded mate-
rial container is correctly inserted
in bottom frame.
For all other malfunctions, check whether
the motor was overloaded before contacting
our customer service. Let the shredder cool
down for approx. 15 – 20 mins. before using
it again.
12

7 Cleaning and maintenance

When cleaning only use a soft cloth and a
mild soap-water solution. However, no water
must enter the equipment.
container (Cross cut only):
• Spray special cutting block oil through pa-
per feed opening across the whole width
of the cutting system blades.
• Press automatic start stop control and run
cutting system forwards and backwards
( - ) several times without feeding pa-
per. Paper dust and particles are shaken
off.
8 Disposal / Recycling
gerous to your health and the environment.
Never dispose of old devices in the house-
hold waste. Observe the current applicable
regulations and use the collection points for
returning and recycling electric and elec-
tronic devices. Dispose of all the packaging
materials also in an environmentally-respon-
sible way.
Classic 102.2 • Primo 1200
english
WARNING
Dangerous mains voltage!
Switch off the shredder and pull
out the mains plug.
Oil the cutting unit when
cutting performance de-
creases or the device
becomes noisy, or every
time you empty the waste
Electrical and electronic old de-
vices contain a variety of valuable
materials, but also hazardous
substances which were required
for function and safety. Incorrect
disposal or handling can be dan-
06/2014