cecotec CONGA HYDRO 3030 ACTIVE Manual De Instrucciones página 28

ENGLISH
3. Install the dust tank to the body.
4. The steam cleaner assembly is done.
4. OPERATION
330 ml removable water tank
The water tank is in the low body. It is recommended to use distilled or demineralised water
instead of tap water. Otherwise, lime deposits may form. Fig. 3
Note:
- Turn the steam cleaner off when removing the water tank.
- Fill the water tank with the water measuring cup.
- Do not use chemical products on the water tank of the steam cleaner.
- It is recommended to remove lime at least once a month.
Steam level control
- The steam level indicator will stop flashing when the steam cleaner is ready to be used.
- Next, press the steam level button to choose the desired steam level.
Fig. 4
Steam control button
Steam level indicator
On/Off switch
Note:
Press the On button and then the steam control button.
Take into account that, when pressing the steam level button for the first time, steam will be in
the maximum level. Set the desired level by pressing the steam control button.
Reusable mop cloths
The reusable mop cloths are machine-washable and suitable for use on virtually all hard floor
surfaces. Your steam cleaner includes two pads. The grey and white striped pads are used for
scrubbing heavily soiled floors and cleaning stubborn debris. Fig. 5
Mop pad
Steam cleaner preparation
Fig. 6
1. Place the pad on the mop head. Make sure that the quick release tab is behind.
a. Fill the water tank.
b. Press the buttons on both sides of the tank to remove it.
c. Remove the rubber plug from the back of the tank.
d. Fill the water tank and place the rubber plug again. For better results, water
28 CONGA HYDROSTEAM 3030 ACTIVE