cecotec CONGA HYDRO 3030 ACTIVE Manual De Instrucciones página 30

ENGLISH
Note
- Make sure the sliding carpet is properly assembled in the mop head. If it is not in the correct
position, the sliding carpet will fall during the use of the steam cleaner.
- Move the steam cleaner continuously until it is finished. Do not leave the steam cleaner in
a steady position.
5. CLEANING AND MAINTENANCE
- Disconnect the power cord from the plug.
- Carefully remove the pad from the mop head. The pad can be hot.
- The remaining water in the water tank must be emptied before storing the device.
- The pad is machine-washable with hot water. Use only liquid detergents. For better
results, do not use softeners nor bleach. Allow the mop to dry.
- Wind the power cord in the hook in the back of the steam cleaner.
- Clean every steam cleaner surface with a soft cloth. Store the device in a protected and
dry area vertically.
- It is recommended to remove calcium in the water tank at least once a month, as well as
using a descaling agent for steam cleaners.
6. TROUBLESHOOTING
Warning:
To reduce the risk of electric shock, turn off the device and unplug it before carrying out any
maintenance or troubleshooting tasks.
Common problems
Problem
Poor or no steam
Water leakage
Difficult use on
carpets
CONGA HYDROSTEAM 3030 ACTIVE
30
Possible cause
Water tank empty
Steam level not selected
Loose rubber plug
Sliding carpet not installed
Solution
Turn off the steam cleaner
and fill the water tank
Select the steam level with
the button.
Turn the steam cleaner and
remove the water tank.
Tighten the rubber.
Make sure the sliding carpet
is properly assembled in the
mop head.