Publicidad
Idiomas disponibles
Idiomas disponibles
b) Install leg protectors into the adjustment frame - main frame (2). Use M8
washers and M8x60 bolts. Slide the washer onto the fixing screw. Move the
assembly through the hole axis, from the top, and lock securely in place.
All connections of the machine should be fixed and pressed correctly. After
completing the assembly activities, it is allowed to start working with the
machine.
Before each use, adjust the height of the of main frame handles according to
your preferences. The height of the machine is adjusted by releasing the height
adjustment lock pin and extending or sliding the adjustment tube. After
determining the desired working height, lock the adjustment tube by placing
the lock pin in a given hole.
NOTE! After each adjustment, remember to see if the height adjustment
lock pin has been seated correctly.
3.3. Cleaning and maintenance
a)
After each cleaning, all components should be well dried before the machine
is used again.
b)
Store the machine in a dry and cool place protected from moisture and direct
sunlight.
c)
Do not spray the machine with a stream of water and do not immerse it in
water.
d)
Regularly inspect the machine for technical failure and damage.
e)
Use a soft cloth for cleaning.
f)
Do not use sharp and/or metal objects for cleaning (e.g. a wire brush or metal
scraper) as these may damage the surface of the machine.
g)
Do not clean the machine with acidic substances, medical products, thinners,
fuel, oil or other chemicals as they may damage it.
h)
Check the fasteners every day before working with the machine.
i)
Every day before starting work with the machine, check the stability of the
installed backrest and seat.
Publicidad
