HP Designjet Z5200 Serie Manual De Instrucciones página 4

2. The spindle has a stop at each end to keep the roll in position. The blue stop can be removed to mount a new
roll; it slides along the spindle to hold rolls of different widths. Remove the blue paper stop from the end of the
spindle.
3. If your roll has a three-inch cardboard core, ensure that the core adaptors supplied with the printer have been
installed.
4. If the roll is long, rest the spindle horizontally on a table and load the roll on the table.
You may need two people to handle a large roll.
5. Slide the new roll onto the spindle. Make sure the paper type is oriented as shown. If it is not, remove the roll,
turn it 180 degrees and slide it back on to the spindle. There are labels on the spindle showing the correct
orientation.
From the back of the printer, the blue stop is fitted onto the right-hand end of the spindle.
3 Introductory Information