Zanussi ZDLN6531 Manual De Instrucciones página 14

6. Turn the cap of the salt container clockwise to
close the salt container.
CAUTION! Water and salt can come
out of the salt container when you fill
it. After you fill the salt container,
immediately start a programme to
prevent corrosion.
HOW TO FILL THE RINSE AID DISPENSER
DAILY USE
1. Open the water tap.
2. Press and hold
activated.
3. Fill the salt container if it is empty.
4. Fill the rinse aid dispenser if it is empty.
5. Load the baskets.
6. Add the detergent.
7. Select and start a programme.
8. Close the water tap when the programme is
complete.
USING THE DETERGENT
A B
1. Press the release button (B) to open the lid (C).
2. Put the detergent, in powder or tablets, in the
compartment (A).
14
A B
A
+ -
C
D
until the appliance is
C
CAUTION! The compartment (A) is for
rinse aid only. Do not fill it with
detergent.
CAUTION! Only use rinse aid
designed specifically for dishwashers.
1. Press the release button (D) to open the lid
(C).
2. Pour the rinse aid in the dispenser (A) until the
liquid reaches the fill level 'max'.
3. Remove the spilled rinse aid with an absorbent
cloth to prevent excessive foam formation.
4. Close the lid. Make sure that the release button
locks into position.
You can turn the selector of the
released quantity (B) between position
1 (lowest quantity) and position 4 or 6
(highest quantity).
3. If the programme has a prewash phase, put a
small quantity of detergent on the inner part of
the appliance door.
4. Close the lid. Make sure that the release button
locks into position.
For information about the detergent
dosage, refer to the manufacturer's
instructions on the packaging of the
product. Usually, 20 - 25 ml of gel
detergent is adequate for washing a
load with normal soil.
Do not fill the compartment (A) with
more than 30 ml of gel detergent.
HOW TO SELECT AND START A
PROGRAMME
1. Press the button dedicated to the programme
you want to set.
• The light related to the button is on.
• The display shows the programme duration.
2. Activate applicable options if desired.
3. Close the appliance door to start the
programme.