Zanussi ZDLN6531 Manual De Instrucciones página 15

HOW TO SELECT AND START THE
PROGRAMME PRE-RINSE
1. To select Pre-rinse, press and hold 30 min for
3 seconds.
• The light related to the button is on.
• The display shows the programme duration.
Options are not applicable to this
programme.
2. Close the appliance door to start the
programme.
HOW TO ACTIVATE OPTIONS
1. Select a programme.
2. Press the button dedicated to the option you
want to activate.
• The light related to the button is on.
• The display shows the updated programme
duration.
By default, options must be activated
every time before you start a
programme.
If the latest programme selection is
enabled, the saved options are
activated automatically along with the
programme.
It is not possible to activate or
deactivate options while a programme
is running.
Not all options are compatible with
each other.
Activating options often increases the
water and energy consumption as well
as the programme duration.
HOW TO SELECT AND START THE
PROGRAMME AUTO
1. Press AUTO.
• The light related to the button is on.
• The display shows the programme duration.
2. Close the appliance door to start the
programme.
The appliance senses the type of load and adjusts
a suitable wash cycle. During the cycle, the sensors
operate several times and the initial programme
duration can decrease.
HOW TO DELAY THE START OF A
PROGRAMME
1. Select a programme.
2. Press repeatedly until the display shows
the desired delay time (from 1 to 24 hours).
The light related to the button is on.
3. Close the appliance door to start the
countdown.
During the countdown, it is not possible to change
the delay time and the programme selection.
When the countdown is complete, the programme
starts.
HOW TO CANCEL THE DELAY START WHILE
THE COUNTDOWN OPERATES
Press and hold for about 3 seconds.
The appliance returns to the programme selection.
If you cancel the delay start, you have
to select the programme again.
HOW TO CANCEL A RUNNING
PROGRAMME
Press and hold for about 3 seconds.
The appliance returns to the programme selection.
Make sure that there is detergent in
the detergent dispenser before you
start a new programme.
OPENING THE DOOR WHILE THE
APPLIANCE OPERATES
Opening the door while a programme is running
stops the appliance. It may affect the energy
consumption and the programme duration. After
closing the door, the appliance continues from the
point of interruption.
If the door is opened for more than 30
seconds during the drying phase, the
running programme ends. It does not
happen if the door is opened by AirDry
function.
THE AUTO OFF FUNCTION
This function saves energy by switching the
appliance off when it is not operating.
The function comes into operation automatically:
• When the programme is completed.
• After 5 minutes if a programme was not started.
END OF THE PROGRAMME
When the programme is complete, the display
shows 0:00.
15