Publicidad
Idiomas disponibles
Idiomas disponibles
h)
When transporting or moving the device from storage to the place of use,
observe the health and safety rules for manual handling applicable in the
country where the device is used.
i)
Avoid situations in which the device stops under heavy loads during operation.
This can cause overheating of the drive elements and consequent damage to
the equipment.
j)
Do not touch any moving parts or accessories unless the device is unplugged.
k)
Do not move, shift, or rotate the device while in operation.
l)
Do not leave the device switched on unattended.
m) Clean the device regularly to prevent permanent dirt build-up.
n)
The provided value of vibration emission is measured according to the
standard measurement methods. The value of vibration emission may change
if the unit is used under different environmental conditions.
o)
The product is not a toy. Cleaning and maintenance must not be performed by
children without adult supervision.
p)
Do not tamper with the device to alter its performance or design.
q)
Keep the unit away from sources of fire and heat.
r)
The unit should be placed on a workbench with a minimum height of 72 cm
and bolted down as necessary to avoid the unit moving/slipping, which can
cause serious personal injury and product damage. The unit should not be
placed above shoulder height! The unit should not be used when it is on the
ground - excessive leaning limits the proper field of vision and control of the
unit.
s)
Use the unit when the weather conditions are favorable. Good lighting is
essential when working with the unit.
t)
The use of protective gloves made of electrically non-conductive
slip footwear and safety glasses is recommended.
u)
Do not open the panel on the motor - any tampering should be done by a
qualified person.
v)
Do not stand on the unit or store objects on it.
w)
No other tools should be in the work area of the splitter. Reaching for them,
especially by a third party, can result in accidental injury.
x)
When using the unit, stay fully focused and constantly monitor its operation.
y)
Keep body parts away from moving parts and from the motor, which can
become hot.
z)
Do not forcefully cut through logs that are too large or have nails, cables, or
other parts. Doing so may cause unpredictable operation of the unit or damage
to it.
aa) The unit is designed for use by one person.
bb) Do not transport the loaded machine.
cc) When lifting the unit, place the harness at the designated points on the unit.
dd) Do not apply mechanical pressure to the unit. Do not tap or strike the unit to
remove a blocked log.
material,
non-
Publicidad
