hillvert HT-LS-5000 Manual De Instrucciones página 61

B) Align the two mounting holes of log tray 1 with the holes on the back of the
unit. Insert one M6 × 12 capscrew and spring washer 6 into the left mounting
hole, and the second M6 × 12 capscrew and M6 locknut on the right. Then
tighten them firmly.
Remove the capscrew and nut on the left side of the front leg, insert the open
end of the spacer 1 onto the screw, then tighten the nut. Connect the upper
end of the spacer 1 to the log shelf 1 with the M6 × 12 countersunk screw and
the M6 locknut and tighten.