Diono Radian 3RXT Manual De Instrucciones página 36

6. Slide the LATCH/UAS strap
through the rear-facing belt
path and out the other side. The
LATCH/UAS strap should lie flat
and not be twisted.
7. Attach LATCH/UAS connectors
to vehicle LATCH/UAS anchors
and listen for audible "click" to
confirm engagement.
8. Tighten the LATCH/UAS strap.
Press down firmly in the center
of the car seat while tightening
the LATCH/UAS strap. You may
need to tighten further by pulling
upwards in-line with the belt
path as shown.
9. Test for tightness. Grab the side
of the seat with one hand where
the LATCH/UAS strap is and slide
the car seat side-to-side and front-
to-back. If the seat moves less than
1 in (2.5 cm), it is tight enough.
Do not test by grasping the top or
back of the car seat.
36
Radian® 3RXT
6
7
8
9