Publicidad
Idiomas disponibles
Idiomas disponibles
Keep the unit in standby while setting it up (
D
on page 5).
1
Place it on a flat surface.
Since the heights of this unit's feet cannot be adjusted,
be sure to place it on a flat surface.
2
Install the turntable (platter).
Align the turntable (platter) with the center shaft and
install it.
Center shaft
Turntable (platter)
3
Loop the belt around the motor pulley.
The rubber belt is wrapped around the sub-platter. Use a
finger to pull the rubber belt through the round opening
and loop it around the motor pulley.
o Be careful not to let the rubber become twisted.
o Rotate the turntable (platter) several times to make
sure that it is secure.
Round opening
Motor pulley
Rubber belt
6
Preparing the record player
4
Place the felt mat on the turntable
(platter).
Place the mat that is included with the turntable on it
before use.
5
Install the counterweight.
Place the counterweight over the end of the tonearm
and turn it clockwise to tighten it.
Counterweight
6
Install the headshell.
Insert the headshell on the end of the tonearm and turn
the nut to secure it in place.
Nut
Headshell
Balancing the tonearm and adjusting the
tracking force
Counterweight
Tracking force adjustment ring
Center line
Anti-skating dial
Tonearm lifter
1
Set the anti-skating dial to zero.
2
Move the tonearm clasp to the right to
release the tonearm.
Clasp
3
Lift the tonearm lifter and shift the
tonearm to the left slightly.
4
Lower the tonearm lifter.
5
Turn the counterweight and adjust so
that the tonearm is level.
o Remove the protective cap from the cartridge stylus
before adjusting.
o Be careful not to let the cartridge stylus touch the
unit.
6
Return the tonearm to its original posi-
tion, and move the tonearm clasp to the
left to lock it in place.
7
Turn the tracking force adjustment ring
so that the center line aligns with 0 on
the scale.
o Be careful not to let the counterweight turn.
8
Turn the counterweight so that the track-
ing force adjustment ring scale matches
the tracking force specified for the
cartridge.
o Turn it from 0 in the direction of 0.5 and 1.
o The tracking force of the included cartridge is 3.5 g.
For 3.5g tracking force, turn the counterweight in
the direction of the arrow in the illustration below
around one time completely so that the tracking
force adjustment ring passes 0 and then keep turning
it until 1 aligns with the center line. (Do not turn the
ring by itself.)
1
Publicidad
