Teac TN-280BT Manual Del Usuario página 8

Playing records
o Remove the protective cap from the cartridge stylus before
using the turntable.
1
Press the STANDBY/ON button on the
back of the unit to turn it on.
2
Open the dust cover slowly.
V Be careful not to pinch your fingers, for
example, when opening and closing the
dust cover.
3
Place a record on the turntable (platter).
When playing a 45 RPM large-hole single record, use the
included adapter.
8
Basic operation
4
Set the rotation speed (RPM) according
to the record.
The rotation speed can be set to 33 1/3 or 45 RPM.
5
Turn the START/STOP rotation knob to
START to start the turntable.
o When the START/STOP rotation knob is set to START,
the turntable will start rotating and the blue LED
will light.
6
Move the tonearm clasp to the right to
release the tonearm.
Clasp
7
Raise the tonearm lifter.
Tonearm lifter
Tonearm
o You can also leave the tonearm lifter down and move
the raised tonearm over the record and then lower
the tonearm slowly to start playback.
8
Move the tonearm to the edge of the
record or the track where you want to
start playback.
9
Use the tonearm lifter to lower the
tonearm.
The tonearm lowers slowly until the stylus touches the
record and playback begins.
o Close the dust cover during playback. Since doing
this prevents skipping caused by unintended contact
and blocks external sound pressure, it makes noise
less likely to occur.
V Do not place anything on the dust cover.
ATTENTION
o During playback, do not touch the tonearm or the rotating
record. Doing so could damage the stylus tip and cause
scratches on the record.
o Do not forcibly stop turntable rotation during playback.
Since this product is not a turntable designed for DJs (direct
drive), doing something like this could cause malfunction.
If the volume is too loud during record playback, vibration
from speakers could be transmitted to the stylus, causing
loud feedback. If this happens, lower the volume of the
amplifier.
When playback finishes
1
Lift the tonearm lifter or the headshell
hook and return the tonearm to its rest-
ing position.
Tonearm lifter
Tonearm
2
Turn the START/STOP rotation knob to
STOP to stop the turntable.
o When the turntable stops, the blue LED will also
become unlit.