Publicidad
OPERATING INSTRUCTIONS
4. LED Worklight
The LED work light (B), located on the front of the
saw, automatically turns on with a slight squeeze
of the trigger switch before the tool starts running.
This provides additional light on the surface of the
workpiece for operation in lower-light conditions.
The LED work light will turn off approximately 10
seconds after the trigger switch is released.
a. The LED work light will go out if the tool has
automatically stopped working because of an
overload or overheating, or when the battery
charge is very low.
5. Shoe Adjustment
For maximum control and longer blade life, the shoe
(A) slides in or out to provide support through the
effective stroke length.
a. Remove the battery pack from the saw.
b. Press the shoe-release button (F) to release the
shoe (A).
c.
Pull the shoe to the desired position.
d. Release the shoe-release button to its original
position to lock the shoe.
WARNING:
• Do not push the shoe-release button while
sawing. It will cause the shoe to release from the
desired position and cause loss of control and
injury.
• To reduce the risk of injury, be sure the blade
extends beyond the shoe and all the way through
the workpiece throughout the entire stroke. Blade
may shatter if it hits the shoe or the workpiece.
Pivoting the Shoe
The shoe (A) pivots to provide maximum contact
with the surface being cut.
a. Hold the saw securely, and then manually pivot
the shoe to the desired angle.
WARNING:
• To avoid injury and damage, do not operate the
saw without the shoe in place. The shaft may strike against the workpiece and damage the
reciprocating mechanism.
4
5a
A
WRONG
5b
A
11
B
F
RIGHT
Publicidad
